The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - Transmission question (https://67-72chevytrucks.com/vboard/showthread.php?t=623196)

4th Gen C-10

03-31-2014 10:02 PM

Transmission question

I am going to be putting in a ZZ4 and 700R4 transmission in my 69 C-10. I know I need to get a new crossmember to go with the tranny. My question is should I get the engine and tranny/crossmember for a mock-up before I send the frame to the powdercoater or can I mark/drill any needed holes once it gets back?

Thanks

ulakovic22

03-31-2014 11:39 PM

Re: Transmission question

You can do either, but I would mock it all up before hand so you don't have to worry about messing it up. You will probably have to clean out the holes with a drill bit after you get it back anyway since the powder will shrink them a little.

All times are GMT -4. The time now is 09:00 AM.