parts for sale
 

I have a list of parts that need to go, so I can have more room. Of course if you are interested shipping will be on your nickel.

master cylinder with booster and proportioning valve this all came off of a 71 or 72 blazer $40.

orginal 1970 spindles with the drums etc attached. $10 for the pair ( converted to disc)

1 plentiful and hard to sell gas tank $10 that price is very negotable. (converted to a rear tank)

1 fuel sending unit that worked with the above tank. $10

1 green glove box door. $10

1 green ash tray ( the kind with ball bearings) $5

C/10 side markers $2

bow tie from the hood $1

1 heater control $5

Just reply or pm if interested. If not the trash pile will increase.

i have an ashtray i need the piece the ashtray slides into and mounts into the dashboard is that included?

Disc or Drum?
 

Is this setup for disc or drums? Wootdog

If the heater control is for a non air, chrome (not black), and in good working order I'll take it. Pic would be appreciated (SDELVY55@aol.com).

Thanks.

Very good prices.. Put me second in line for the heater control, if all three slides are good...
email me@
PBJohnson2@aol.com
Thanks

Old Rusty C/10 The Ash tray is just the tray. I pulled it out of my dash and have replaced it with a chrome one. Nothing wrong with the green one just changed the color.

Wootdog The set up for the spindles is for drums. They are 6 lug.



Scott H The heater control is non air, chrome, and I went look at it, it will need two out of the three knobs replaced. They slide fine but the tips are broken off. That is why I'm going low with the price. I probably can get pics out tonite or tommorrow morining if my cousin is avaiable. I don't have a camera.

Phillip Johnson I guess you ou for seconds b/c of the knob situation.

Hope this answere all questions. If not keep asking. If you don't like a price we can talk. I mainly want to get rid of these parts without trashing them.

later































\\\\\\\

Please disregard my typing errors. I was lazy and did not proof read.

Does the MC leak around the top? Was everything working well as far as you know. Do you know if this will work on a 3/4 ton PU. Shipping to 26003?

N b
 

Hey Chucks 70 as far as I know everything was in good order. I'll have to check shipping and if it can be uses on 3/4 ton. Can anyone that reads this pipe in if you see the question about the mc and if can be used on 3/4 ton

Let me know what shipping is on the heater control to 08753 and how you would like payment. Also which knobs are broken?

Thanks.

Do you have any six lug hubs?

Scott H the shipping on the heater is $5.71 The broken levers are the two top ones. they are broken riight flush with the face of the heater conrtol which warrents replacement.

Chucks 70 the shipping for the Master Cylinder is 16.50. Let me know your decision

jhwkns The hubs are on the spindles. When I switch to disc I didnot remove the drums , hub, shoes, cylinder or anything from the spindles. Everything is there. Let me know what you think.

PM sent.