The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - Help with spindle (https://67-72chevytrucks.com/vboard/showthread.php?t=646959)

scrapmetal

10-19-2014 04:18 PM

Help with spindle

1 Attachment(s)

Well I was driving down the road and my drivers side bearings literally fell apart, I'm in the middle of replacing them but can't find an exploded diagram in the manual I have that shows this part. Can anyone tell me what it is ? The truck is a '68 with drums. Thanks for any help.

Xeen	10-19-2014 04:45 PM

Re: Help with spindle

You should have a washer with a tang on the inside to keep it from spinning that goes on between the bearing and the castle nut.

primetime

10-19-2014 07:06 PM

Re: Help with spindle

looks like the center of the bearing that the needle or ball surrounds

primetime

10-19-2014 07:12 PM

Re: Help with spindle

i believe its called the race, but you need to cut it off before installing the new bearing. chisel or dremel should handle it

All times are GMT -4. The time now is 06:23 AM.