The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1947 - 1959 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=13)
-   -   rear cab cross member (https://67-72chevytrucks.com/vboard/showthread.php?t=695692)

sqweaka 01-24-2016 01:12 PM

rear cab cross member
 
hi all i was going to leave the xmember at the rear of the cab in place on my bagged 49, and use a split prop to get round it during the drop, but ive now changed my mind i think and want to cut a section from the centre of the xmember to allow for a single piece prop, can i see pic's of how others have modified theirs please! its just visible under the rear of the cab

http://i1168.photobucket.com/albums/...psvtkq3upq.jpg

mr48chev 01-24-2016 04:54 PM

Re: rear cab cross member
 
That's a heck of a lot of extra effort to go to just to run a 1 piece driveshaft. I can never understand why guys are so blooming afraid of 2 piece driveshafts as long as they are done right.

If you go ahead and go one piece I'd say weld in a piece that resembled a driveshaft hoop on a race car in the area you cut out and then cut a notch in the front of the box and do something similar and then on the back of the cab.


All times are GMT -4. The time now is 02:10 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com