The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   Mounts for 327 installation in '78 C10 (https://67-72chevytrucks.com/vboard/showthread.php?t=720827)

clockdoc 10-23-2016 01:14 PM

Mounts for 327 installation in '78 C10
 
Hello folks. I'm building a 1965, 327 block to install in my 1978 C10 shortbed. Will the stock motor mounts match up to the '78 frame mounts?

Any info will be appreciated.

Alex

flatbed82 10-23-2016 02:43 PM

Re: Mounts for 327 installation in '78 C10
 
Use the clamshells that came off of the truck, no problem.

clockdoc 10-23-2016 06:22 PM

Re: Mounts for 327 installation in '78 C10
 
Thanks Flatbed

barry1982 10-23-2016 11:23 PM

Re: Mounts for 327 installation in '78 C10
 
Hi there, are you using the original 1965 heads? I ran into trouble installing a 1965 283 into my 76 years ago. I installed 350 engine mounts, that was no problem. I did run into problems with the 283 heads did not having the "tapped" holes in the heads to mount my alternator. Also had trouble mounting the P/S pump. The 327 may have the tapped holes, I can't recall.

clockdoc 10-24-2016 08:26 AM

Re: Mounts for 327 installation in '78 C10
 
Hi Barry. Yes, that's going to be an issue. No holes in these heads either. The P/S pump mounts to the driver's side motor mount holes, but A/C and alternator will require after-market brackets that use other fastening points.

Alex

geezer#99 10-24-2016 09:35 AM

Re: Mounts for 327 installation in '78 C10
 
Quote:

Originally Posted by clockdoc (Post 7750654)
Hi Barry. Yes, that's going to be an issue. No holes in these heads either. The P/S pump mounts to the driver's side motor mount holes, but A/C and alternator will require after-market brackets that use other fastening points.

Alex

Easy to cure with a couple bucks. Look here for conversion brackets.
http://www.alangrovecomponents.com/

clockdoc 10-24-2016 07:39 PM

Re: Mounts for 327 installation in '78 C10
 
Thanks Geezer. Very helpful info.

Alex


All times are GMT -4. The time now is 02:27 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com