The 1947 - Present Chevrolet & GMC Truck Message Board Network - MN 250-292 Intake and Exhaust manifolds restored

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967-1972 Chevrolet & GMC Pickups Parts Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=8)

- - MN 250-292 Intake and Exhaust manifolds restored (https://67-72chevytrucks.com/vboard/showthread.php?t=741479)

250-292 Intake and Exhaust manifolds restored

Have your choice of a pair of intake and exhaust manifolds i prepped to use on my 250 build, but stumbled into a set of Clifford intake and headers and no longer need these.

First is my first/original set that I had a machine shop bake and shot peen for me. Castings are real nice and will work great in a stock application. $30 plus shipping to lower 48.

Second is a set I found that has the larger 2.5" exhaust manifold from a 292 in a medium duty truck. This set I again paid to have baked and shotpeened. I then painted the intake with ceramic high temp paint and the exhaust manifold was coated in Eastwood's high temp cast coating. I also installed new studs and a heat separator gasket. Had this set installed on the finished engine before the Clifford set up kind of fell into my lap. If I had to do it over again, I would have just stayed with this setup and run an adapter for a Rochester 2Jet carb. This set I need $175 plus shipping, but could swap on with zero mods and your up and running.

First Ill take it.

--Mike