The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - Dip Stick Tube (https://67-72chevytrucks.com/vboard/showthread.php?t=746039)

davischevy

09-05-2017 12:13 PM

Dip Stick Tube

I'm replacing the dipstick tube in my 72 with 350 engine. Does anybody have any tricks on how to press the tube in the block?

Jcfcamaro

09-05-2017 12:21 PM

Re: Dip Stick Tube

An open end wrench around the flange and tap the wrench with a hammer will work .or a flat punch

davischevy

09-05-2017 12:35 PM

Re: Dip Stick Tube

I used a line wrench. It slid on and stayed by itself while I tapped it with a long screwdriver.

A nut would have worked well. Just slide it over the tube and tap with a punch or screwdriver.

Jcfcamaro

09-05-2017 02:02 PM

Re: Dip Stick Tube

I also put some high temp RTV silicone about 1/2 in down from the flange to seal it up good.

All times are GMT -4. The time now is 07:17 AM.