55 to 59 door molex (wiring boots)
 

What is everyone using? I came up with nothing from the usual parts suppliers...

The boots to run wires from the post to inside the doors

Re: 55 to 59 door molex
 

Re: 55 to 59 door molex
 

No, the boot for running wires from the post to the door....Like for speakers or power windows

Re: 55 to 59 door molex
 

Sorry Dave, I used the Painless Performance contacts for my door solenoid wiring.

https://www.summitracing.com/parts/prf-40021

Re: 55 to 59 door molex
 

you could run plastic corrugated tubing, I've seen that done and it's cheap.

Re: 55 to 59 door molex
 

Re: 55 to 59 door molex
 

I was wondering what everyone else has done.

Re: 55 to 59 door molex
 

These work nicely. I use then often.

Re: 55 to 59 door molex
 

I made these. For some reason they look a lot like the ones Ogre made. :D

Re: 55 to 59 door molex
 

I'm going to do plastic tubing, o-ring and grommet like this:
http://www.watsons-streetworks.com/m...tic-wire-looms

Re: 55 to 59 door molex
 

i tried the flexible braided loom and didn't have much success with it
1st it is very small, if you only need small speaker wires in the door you may get it to work
2nd the hinge pivots on tf trucks moves the door in a sliding movement more than a swing motion

the enginerd in me drew this 1st pic up so i could design the door loom dan made
the tube is 3/4'' square aluminum, flat stock is 2''x1/4'', roll pin pivot; all bought from my local home depot
installed pics show full open and mostly closed positions

the 3/4'' sq tube allowed 6 wires: 2 #16 speaker, 2 #14 power window and 2 #14 power solenoid wires
the red plastic washers in dan's pic are slide bushings for the door

Re: 55 to 59 door molex
 

steal my design AND MY OGRE SMILEY???? :D:D:D
you have overstepped my forum rules :D

did you ever install them dan?

Re: 55 to 59 door molex
 

It's Bob! I did a temp install, and they're great. I would never steal your Ogre smile. I put it there in your honor, and for you to be sure to see that I stole your design. Great work!

I've recently put about 50-60 hours into panel fitting recently in hopes that I can paint in the spring. Nothing's gone into the build thread because it's like watching grass grow...