1960 w/crossmember swap, what headers?
 

Project is a 1960 c10. Just did the crossmemeber swap going to a 350/TH350. I can't get a good answer on what long tube headers I can use. I don't plan on slamming it, might lower it an inch or 2, that is it. Headman gave me a number but I don't have the torsion bars anymore. Not real fund of their tube placement.

I am open to ideas and pictures are a huge plus. Thanks all!!

Re: 1960 w/crossmember swap, what headers?
 

Since your not running a clutch the Hooker 2466 mids work. But long tube for ground clearace use fender exit and run down sides. Unless your pushing 500hp the diff is little if any.

Re: 1960 w/crossmember swap, what headers?
 

Look in the faq section for other threads

Re: 1960 w/crossmember swap, what headers?
 

Last 2 pic are another memebers. Pypes tunnel X

Re: 1960 w/crossmember swap, what headers?
 

Oh, I have and made notes

Re: 1960 w/crossmember swap, what headers?
 

ADMIN: Please delete this thread because I can't figure out how to do it. thanks

Re: 1960 w/crossmember swap, what headers?
 

Since you are wanting long tube headers and have eliminated the torsion bars, and are going with an auto trans, you can use any brand truck header for a '55-'87 truck.

Re: 1960 w/crossmember swap, what headers?
 

Thanks for that very important info. I tried some from a 78 van and the pointed right at the x frame.

Thanks again!!

Re: 1960 w/crossmember swap, what headers?
 

If you look at the pictures I posted, the 3/4s drop right at frame. So if your not running 500+ hp there is no reason to run the header any lower. If you must have long tube use fender well headers and run down side

Re: 1960 w/crossmember swap, what headers?
 

Just came onto a new set for an 84pu, will fit fine might have to tweek but all is good, thanks Capt. Fab!!

Re: 1960 w/crossmember swap, what headers?
 

Just tried a new set from a 84 pu, will work just fine. Thanks for the info!!