The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- 67-72 Chevrolet & GMC Pickups Projects and Builds (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=115)

- - Driveshaft yokes (https://67-72chevytrucks.com/vboard/showthread.php?t=778298)

KMAT	12-28-2018 11:52 AM

Driveshaft yokes

1 Attachment(s)

Since I have had such good luck will try one more time everybody has been so helpful okay so I needed a length in my drive shaft inch and a half went and got a longer yolk from the salvage yard which will work but it has this round like vibration dampener attached to it. Question is should I use it and leave it on does it come off or not use it at all any information would be much appreciated I will try see if I can figure out how to attach a picture once again since I forgotten go figure.

notsolo

12-28-2018 02:13 PM

Re: Driveshaft yokes

I don't see why not, if the Splines are the same? There is 1" or so space between back of the trans and yoke? U joints are the same? use it as is.

KMAT	12-29-2018 03:10 AM

Re: Driveshaft yokes

Rite on!!! This is why i dig this site.No bull chit answeres,or snide remarks.
Thanks, and yes ujoint is same dia..Ive just never seen this type of dampener on a yoke befor.

All times are GMT -4. The time now is 11:53 AM.