Specialty Power Window kit
 

Got my Specialty Power Window kit test fit in the door. I wanted to see what had to be done so I could do any patches or repair after it was test fit.

It went in ok, but there is a bolt head that sits on the inside of the door about 10" down from the bottom of the window, when rolled up.

Has anyone installed this kit, and if so, what did you do to camoflauge that bolt in the middle of the door?

Thanks.

Re: Specialty Power Window kit
 

Swapping the hex head for a round head machine screw would help an maybe using one that uses an allen wrench would make it easier to tighten. Paint it the same color as the door and it might not show up too much.

Re: Specialty Power Window kit
 

Thanks. That's probably what I'll have to do.