The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1960 - 1966 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=6)
-   -   Windshield Opening Vertical Dimensions (https://67-72chevytrucks.com/vboard/showthread.php?t=779595)

TxCajun 01-15-2019 07:37 PM

Windshield Opening Vertical Dimensions
 
Windshield Opening Vertical Dimensions?

When found, my truck had a broken windshield and a lot of rust above the windshield on both the inner and outer roof panels. I'm working to repair that rust with some parts cut from a donor roof. Just to be sure that my old roof had not "sagged" in the rust weakened area, I'd like to check the vertical dimension of the windshield opening.

I'm interested in the distance between the top windshield gasket flange and the bottom windshield gasket flange. The dimension at the center would be good, and maybe one foot on either side of center if there is any taper in this area.

I did a forum search and could not find these dimensions. Any help would be greatly appreciated.

Thanks!

Robert Haas 01-15-2019 10:10 PM

Re: Windshield Opening Vertical Dimensions
 
1 Attachment(s)
sure here you go

center tip of pinchweld flange to flange 18 7/16"

lower body seam at pinchweld straight up 17 5/8"

here is a picture, my measurements are straight up no angled to the upper corner like my diagram.


Attachment 1865251

TxCajun 01-16-2019 11:12 AM

Re: Windshield Opening Vertical Dimensions
 
Robert, Thanks! Dimensions are just what I needed.

BTW, Really enjoy your build thread!


All times are GMT -4. The time now is 12:18 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com