![]() |
CFR performance valve cover adapter plug wires
1 Attachment(s)
For those of you (if any) using the CFR Performance valve cover adapters on your LS, what did you use for plug wires? The factory 6.0 plug wires are not long enough so I tried a build your own plug wire kit but the coil side was too small of a boot to fit on the coil (even tho it said they fit truck LS coil packs). If I had to do it again I would not buy these adapters as nothing fit all that great, but i'm determined to run em at this point with the factory coil packs I have (2006 6.0 lq4). I'm open to any opinions short of chucking these things...maybe.
Valve cover link for reference: https://www.cfrperformance.com/HZ_80...z-8000-pbk.htm |
Re: CFR performance valve cover adapter plug wires
When I relocated my coils I used a set of cut to fit plug wires for an older LT1, they had the correct ends.
|
Re: CFR performance valve cover adapter plug wires
I used Taylor cut to fit wires...but the LS coil side boot is seperate
|
Re: CFR performance valve cover adapter plug wires
Thanks for the ideas i'll check it out
|
Re: CFR performance valve cover adapter plug wires
I put a bunch of money into trying to make these work on mine. I gave up. In my opinion they're poorly engineered and made. A classic case of "you get what you pay for."
|
Re: CFR performance valve cover adapter plug wires
I dont get it, the stock LS covers are simple, and clean.. any cleaner would be to put a cover on em to bid them
.. these seem to bolt to the covers and make things less everything? |
Re: CFR performance valve cover adapter plug wires
Quote:
|
All times are GMT -4. The time now is 08:33 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com