The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- LSx Swaps (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=206)

- - Crossmember (https://67-72chevytrucks.com/vboard/showthread.php?t=792730)

prodjay10

08-31-2019 04:53 PM

Crossmember

1 Attachment(s)

To get a 5.3L and 4L60e to fit, does the crossmember have to come out?

1971 c10 with 250 cid and manual transmission
Posted via Mobile Device

mongocanfly

08-31-2019 07:59 PM

Re: Crossmember

I would pull it if nothing more than to just it out of the way...it wont be needed...

Captainfab

08-31-2019 11:21 PM

Re: Crossmember

Yes remove the bellhousing crossmember. It is not needed for an auto trans and it will just be in the way.

prodjay10

09-01-2019 12:37 AM

Re: Crossmember

Thanks.

19Loki67

09-02-2019 12:12 PM

Re: Crossmember

nice, this was one of my questions as well. I get to break out the air hammer again

solidaxel

09-02-2019 09:12 PM

Re: Crossmember

You will need to support the rear of your 4L60E, do you have a xmember for the trans mount

prodjay10

09-10-2019 11:04 PM

Re: Crossmember

I have a crossmember for the auto tranny.

I had to remove the manual tranny crossmember like y’all suggested. I also had to disconnect the e brake cable while maneuvering engine and transmission in.
Posted via Mobile Device

All times are GMT -4. The time now is 10:44 PM.