Fender trim quality
 

Is any of the aftermarket wheel opening trim any better than the other.
Seen dynacorn and AMD Or is it all the same?

Re: Fender trim quality
 

No opinions so went with the AMD stuff

Re: Fender trim quality
 

Thanks for posting. I'll need some soon, so if you can please let us know how it turns out.

Re: Fender trim quality
 

I bought two sets of the stuff LMC sells and i was quite happy with it.. I bought some stainless zips and installed it on the two last projects and it was great looks and fits well

Re: Fender trim quality
 

Says 10 days shipping.
Hope it's less and have an update next weekend

Re: Fender trim quality
 

No holes line up. Looks ok on though
And wasn't treated real well in transit

Re: Fender trim quality
 

Update:
the front went on perfect.
Aftermarket fenders and all.

FedEx didnt do it any favors either

Re: Fender trim quality
 

what are your rear wheel/tire specs?

Re: Fender trim quality
 

I have had my wheel well trim on for about 3 years now and they look just like the day I installed them, I also daily drive my truck all year round. I had to drill a couple of holes for mine as well. I also had to "massage" some of the bends in them to make it fit perfect but it wasn't to bad.

Re: Fender trim quality
 

15x10 3.75 bs
295 55 Mickey thompson radial.

But there's a narrowed 9 inch under it.
Stock should be 4.25 or 4.5 bs they rubbed terrible before the 9 inch swap

Re: Fender trim quality
 

shoot. I just bought x10s with 4" BS and was hoping 295s would fit...looking more and more like 275/60s will need to be the route...

Re: Fender trim quality
 

Good luck with them.

Re: Fender trim quality
 

Went ahead and ordered the 295s. Tire shop said I could return and go down a size if I needed to. Worth a shot.

Re: Fender trim quality
 

Depends on your ride height too. My 295 t/a' rubbed hard with a flip kit

Re: Fender trim quality
 

my 4" offset gives me a quarter inch more than you had and after taking measurements of where my current wheels and tires are vs where the new ones will be on a calculator its gonna be within .25" so we'll see. Getting them mounted this afternoon and should have em on the truck this evening. If its close and worth it, I may look into rolling my fenders. Truck is primered and the passenger bedside may need to be replaced anyway.

Re: Fender trim quality
 

They fit...ish. No rub but I don’t daily either so I’m happy

Re: Fender trim quality
 

Looks good!

I ran 295 50 and 245 60 ta's til I went with a drag radial