Fuel line banjo fitting washers?
 

I've got the Edelbrock hard line fitting at the carb part #8131. Can't find the right size washers for the banjo fitting & don't see a listing for them. Can I use the originals multiple times? If not, anybody know what size of replacement will work? Thanks

Re: Fuel line banjo fitting washers?
 

It is a low pressure application. Do a good visual inspection with a magnifying glass and if they look good reuse them.
Are they metal or fiber?

Re: Fuel line banjo fitting washers?
 

They’re usually a copper crush washer like these.
https://www.oreillyauto.com/detail/b...640990/4706968

Re: Fuel line banjo fitting washers?
 

They're metal. Very thin. Not copper. Maybe aluminum? Called Edelbrock. Nice guy. Said I'll have trouble finding them, but he'll send me a couple. Asked him about the size and he admitted he didn't know. Wondering if anyone else has the same setup & used different washers - in case I remove it again.

Re: Fuel line banjo fitting washers?
 

If they were copper I would say to annealed them, but aluminum I'm so not sure it would work on such a thin part. Try searching the interweb for annealing aluminum. I know that aluminum sheet metal formers do it all the time.

Re: Fuel line banjo fitting washers?
 

Is this more like what you’re looking for.
https://quadrajetparts.com/inlet-fit...ck-p-2042.html

Banjo fitting on afb/Edelbrock.

Re: Fuel line banjo fitting washers?
 

Very possibly, geezer#99. Those $5 washers wind up costing $21 shipped, so I might hold off for awhile. Thanks!

Re: Fuel line banjo fitting washers?
 

I just bought the same fuel line last week and read to use copper washers and get rid of their washers especially the Teflon ones.

Re: Fuel line banjo fitting washers?
 

Thanks for all the replies. I just ordered these & will see if they work:
https://allcarbs.com/product/edelbro...-inlet-gasket/