Help with Steering Shaft Removal
 

Hey everyone,
Now that the LS/Trans swap is driveable its time to address some maintenance/repair items on the truck itself. This one has been pretty stubborn. Replacing the lower steering column bearing, I've got the bearing kit here, but can't for the life of me get the steering shaft off of the column

See the arrow below;
https://i.imgur.com/lXYEhKLl.jpg


Where that arrow points - I removed the pinch bolt, and the bulky section with the rubber seal moves down but the shaft itself doesn't collapse at all and I don't want to hammer on it too hard for fear of tearing the rubber boot. Is this just a case of a stuck shaft where I need to drill out/melt out the plastic pins or am I missing something?

Trying to avoid unhooking at the steering box if I can, just because those bolts are all boogered up and ultimately I want to replace the entire setup, so this is just to get it driving a little better.


Thanks in advance
Eric

Re: Help with Steering Shaft Removal
 

I can't help, but I am wanting to do the same thing so following along.... thanks!

Re: Help with Steering Shaft Removal
 

I would first soak the end with a good penetrating oil. Next, disconnect the shaft at the rag joint and get it off the steering box then try to hammer it off using an adjustable wrench around the shaft and striking with a hammer. The shaft is sorta of D shaped and is a really tight fit. When you go to reinstall clean both the intermediate shaft end and the steering column shaft end with some sand cloth and make sure it is positioned properly. Good luck sometimes they are a pain in the butt.

Re: Help with Steering Shaft Removal
 

Thanks very much for the advice! I was really hoping to avoid disconnecting the rag joint end because someone at some point rounded off the pinch bolt, but looks like I'll be getting creative with getting that off.

I guess while I've got it apart the responsible thing would be to replace the rag joint at the same time. Snowball effect :lol:

Re: Help with Steering Shaft Removal
 

It may look rounded but it requires a 12pt socket

Re: Help with Steering Shaft Removal
 

You made me go look again and yup - it was so packed with crud it looked rounded. Cleaned it off and it’s just a 12pt. Shouldn’t be too bad then.

Re: Help with Steering Shaft Removal
 

I usually have to smack them with a hammer to get them to slide off once the bolt is completely out.

Re: Help with Steering Shaft Removal
 

x2. Mine was similar.

Re: Help with Steering Shaft Removal
 

It's been awhile, but from my memory, it comes apart at the steering box a lot easier than at the steering column. I doubt you'll have any trouble. Spray it down with pBlaster overnight, and it should slide right off.

Re: Help with Steering Shaft Removal
 

Thanks very much guys - hoping to tear into this again at some point this week. Gotta go grab some 12pt sockets and I've been hitting both ends with PB every time I open the hood.

Re: Help with Steering Shaft Removal