WTB 68 Panel/Suburban gas filler and marker light body cut
 

Hi guys,
I'm looking for a 68 panel truck/Suburban driver side rear quarter section that has the gas filler hole and marker light area. I prefer to have one rust free piece with both holes as they are close together. A piece that goes from the horizontal body line behind the rear wheel and up 10 inches above the gas filler hole (total of around 16") would be great. I don't need the taillight but it's ok if it is part of the cut. I'm near Chicago and can drive 400 miles or have it shipped (prefer).
This might help show what I need:

Re: WTB 68 Panel/Suburban gas filler and marker light body cut
 

Just sayin

Re: WTB 68 Panel/Suburban gas filler and marker light body cut
 

I saw that but I think it's a little too far. I checked it out and it is over 700 miles :eek: That's the problem with living in the rusty Midwest, everything local is rusted out and all the good parts are down south or out west :(

After doing some work on my truck today I found some frame damage due to rust. The area above the rear coil springs is rusted away and kinda collapsing. It is also very thin from the gas tank and back. I really need to find someone cutting up a frame. I can use the back half of the frame from the crossmember where the truck arms connect, all the way back to the rear bumper. That would solve a lot of problems.

Re: WTB 68 Panel/Suburban gas filler and marker light body cut
 

Good news. I found a rear quarter so I'm all set. Thanks