Blazer body mount question
 

I have a 72 blazer 4wd that has has some interesting mods from the PO. Can anyone tell me if these look like stock bushings? If I remove the aluminum spacers, will I be at stock height? This is my experience with a blazer, so I'm not sure what the stock ones would have looked like.
Edit: I apologize for the sideways pics

Re: Blazer body mount question
 

Hi those do look like stock style bushings under the spacers, they could be the polyurethane ones instead of stock rubber. I personally would not reuse the bushings as some might have had more load on them than others that squished them down and that may require more shims etc to level properly. It looks like the previous owner did a body lift.
If you were going to go through all the work of getting rid of the spacers new bushings would make sense to do at same time

Re: Blazer body mount question
 

I think those are the polyurethane ones

Check out this thread it has some pointers and diagrams

http://67-72chevytrucks.com/vboard/s...d.php?t=340108

Re: Blazer body mount question
 

I replaced my body mount bushings with rubber ones from Wes at Classic Heartbeat (he's a board member). The parts were first rate and the service was excellent.

Re: Blazer body mount question
 

Thanks for the replies! I'm certain these are rubber and not polyurethane. I'm just trying to get it back to stock height. I want to get rid of the body lift, as well as the suspension lift that is waaayyy too much for my taste. I will look into the set from Classic Heartbeat.

Re: Blazer body mount question
 

That leaf spring mount is scary. I would worry more about that then the body bushings

Re: Blazer body mount question
 

Trust me, I know. There are a lot of things under there that are that scary or worse. I was being nice when I said the PO's mods were "interesting" That's why it's all coming off and going back to stock. And don't worry, I have not, and will not drive it like it is currently