Easy spindle bearing removal
 

This was so easy I figured I would share it
Pretty much all you need is a pc of 3/8" threaded rod, a couple of washers, nuts and a pc of wood.
Add 2 nuts and a strong washer (or 2 thinner ones) to the end so they stick out enough to catch bearing

https://www.beamingpix.com/images/20..._1365x1024.jpg

https://www.beamingpix.com/images/20..._1024x1365.jpg

So the trick here to make this work is insert rod to catch the back lip of the bearing, the critical part is wedge a pc of wood in the spindle and tap it down with a hammer to hold the rod against spindle wall nice and snug. A couple of taps on the rod with a hammer and the bearing falls right out

https://www.beamingpix.com/images/20..._1024x1365.jpg

https://www.beamingpix.com/images/20..._1024x1365.jpg