The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   Measurement PLEASE. K10 cab bushing height (https://67-72chevytrucks.com/vboard/showthread.php?t=829251)

tutone 12-30-2021 08:41 AM

Measurement PLEASE. K10 cab bushing height
 
Hey guys, I need someone to measure a fairly fresh cab bushing spacing from the solid frame mount to the cab floor. Front and back. One side is fine. Reason is, I set my cab on the frame , just to get it out of the way, and it is rocking on my xfer case at the center brace behind the high hump hole. I may not have a problem, and again I may. Thanks.

Richard 12-31-2021 05:18 AM

Re: Measurement PLEASE. K10 cab bushing height
 
Sorry you have not had any response. Will get you some measurements tomorrow later in the day. I installed mounts purchased from Classic Hearteat (Wes). Note the mounts I had originally installed from LMC were to short by 3/4"- to 1". Not any interference though. Have seen on the forum that this is not uncommon. Owned a K-20 and currently a K-10 I am working on now myself. From what I understand K10, K20 and C20 rear mounts are al the same. Only the C-10 rear cab mounts are different.

tutone 12-31-2021 09:37 AM

Re: Measurement PLEASE. K10 cab bushing height
 
Thank you. I have a set of bushings, (unopened), and since I swapped this over to a different case, I am thinking I have clearance issues. My bed is perfectly aligned so if the cab works out. Im good.

72again4x4 12-31-2021 10:57 AM

Re: Measurement PLEASE. K10 cab bushing height
 
2 Attachment(s)
Tutone,
Hope these help. Let me know if you need a different angle or measurement.
Roger

72again4x4 12-31-2021 10:59 AM

Re: Measurement PLEASE. K10 cab bushing height
 
Also, I haven’t measured floor to mounts or cab brace yet. My bolts may be loose which may cause these measurements to be slightly off.
Roger

tutone 12-31-2021 12:27 PM

Re: Measurement PLEASE. K10 cab bushing height
 
Thank you sir. My cab mounts are in the correct place so no further measurements required. I assume that after replacing your bushings with these, you are happy with cab to bed alignment. Otherwise, you would be like me searching for the right height. I will cut spacers to that height and slip them in to see if I do in fact have a problem. Seeing the 2 5/8 measurement on the back gives me hope.

72again4x4 12-31-2021 12:30 PM

Re: Measurement PLEASE. K10 cab bushing height
 
Yes sir, cab sits nice and no movement when I work on it. I may tighten down a turn or two still. Glad I could help.


All times are GMT -4. The time now is 12:50 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com