wtb driveshaft
 

I'm looking for a driveshaft to bolt into my 67 with a turbo 400 trans. It needs to be a minimum of 70 1/4" long and a max of 70 3/4 " long. I believe a drive shaft out of a big block longbed 2 wheel drive truck has the correct length that I'm looking for.:confused:

bump

2-piece? I have a 2-piece driveshaft, but i'll have to measure it to see if it's the right length. I'll try to check on it this evening.

Jason

I have a one peice out of a 67 LWB GMC it is 68-1/2in long measuring from u-joint to u-joint this is not counting the yoke

Im going to cut 3'' out of my old one thanks.

bumb

I have a factory original 2 piece out of a 69 2wd long bed, big block truck with the 400 yoke on it. Has the heavy duty carrier bearing. All in bolt in condition. $ 65.00 plus shipping. I might be able to get it to Teeitups for a small fee, if you can pick it up there. PM me if you're interested. Thanks

Thanks to everyone who responded... However redneck has decided to go ahead and have his old driveshaft cut to fit.. thanks again to everyone for their input.....