Pictures of Lowered Burbs (3/5 vs 4/6)
 

Getting ready to place the order for my suspension however I am not sure if I want to go 3/5 or 4/6. Going to be a static drop and want to be able to drive without to many issue but love the low look. Already have wheels bought, 20X10 in rear 20x8 up front.

Can you guys post up some pictures of these different set ups (3/5 vs 4/6). I tried searching but didn't find much, if there is already a thread covering this if you could point me to that that would be great too. Thanks.

Re: Pictures of Lowered Burbs (3/5 vs 4/6)
 

Did you see this thread?

http://67-72chevytrucks.com/vboard/s...ad.php?t=68579

Re: Pictures of Lowered Burbs (3/5 vs 4/6)
 

In a week or two I should be able to get some good pics of my Burb on a 3.5/5 with 20" wheels. Is your frame notched? 6" might be cutting it close, just based on where my Burb is sitting at 5".

Re: Pictures of Lowered Burbs (3/5 vs 4/6)
 

3.5/5
245 45 20 / 275 40 20

Re: Pictures of Lowered Burbs (3/5 vs 4/6)
 

Thanks for the picture. I just placed my order yesterday. Starting out ar 3.5" up front (2.5 modual drop spindles and 1" lowering spring) and 4" drop springs in the back. We'll install all that and see how it looks and go from there. If it isn't low enough I also ordered up a 1" block so if I want to go lower I can cut 1/2 a coil up front and put that block in. Going to be a bit before I can get it all installed but will post up some pictures.

As for notching, I did order up a HD notch kit and will install that at the same time.