Wanted:74’ GMC Jimmy/Blazer parts
 

Looking for the following parts for my 74’ GMC Jimmy build.

-Tailgate
-Bedsides/bed floor
-doors
-windshield frame
-15” steel wheels
-original spare wheel/tire
-inside spare tire carrier
-floor shift tilt steering column
-1974 GMC grille
-73-75 bucket seats

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Have a in side spare tire carrier listed here, about 8-9 threads below this. Solid with no rust if interested.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Thank you for the replies. Unfortunately that carrier is for a late 70’s-91 K5? The one that was in my 74 goes directly behind the drivers side back seat and faces out the back. Also, I’m looking for a floor shift tilt column as my truck has a 4 speed manual transmission. The hunt continues!

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

I tried, lol

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

You’re looking for the same style that came in the 69-72 k-5’s sounds like. People forget they also came in some of the early square k-5’s before switching to the rod style

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Thanks for the reply. Did not realize the early K5s used the older 69-72 spare tire mount. I had a 71 K5 that did have the swing away outer spare tire mount bolted to the passenger side rear quarter. Years later I had a 77 K5 and it had the same style spare mount as I have listed. Still learning after all these years the little tid bits of info, LOL. Good luck in your search. :chevy:

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

The swing outs were an aftermarket option, Hickey I believe. Yea the earlier style carrier is not common in squares. I was fortunate enough to hunt down 2 for my builds. 10 times more rare and pricey than the rod style

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Seats,grill,doors,windshield frame,spare tire carrier,steel wheels,and tailgate from one of my 74 GMC---3200 shipped.pm me if ready to buy.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

2500 cash if you appropiate pickup.parts are located in NM 87532.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

73-74 had 69-72 style. 75-78 switched to rod style

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

smupser, thanks for posting that pic. That clears up for sure what the two differences are in the square body Blazers spare tire mounts. Good info there, thanks. :chevy:

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

No problem Gary, that’s what we’re all here for.

To put it in perspective, the later rod style don’t go for much, most average for a complete setup at $150 or less. The earlier style go for at least $550-600 just for the carrier, more if you’re lucky enough to find one with all the correct parts. I think I paid around $600 a piece for two of them and both only had a couple of the parts with them. This is because they’re also 69-72 K5 carriers, which any hard to find part for those years, is worth their weight in gold.

Sorry to OP for the thread jack, just wanted to add some knowledge on what you were looking for.

Aaron

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

I’ve got a pair of bucket seats one is pretty good one will need some welding. Both driver and pass mount hardware is included 350.00 plus shipping from west Kentucky

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Are you still looking for a 74 GMC grille? I think I have one.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Yes I am. pm sent

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

there’s i spare tire carrier in the 69-72 blazer section for sale

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

I’m parting out a 77 jimmy currently, I have the bucket seats, tailgate and the sheet metal. I have 15x8” dog dish steel wheels as well. I’m motivated to sell stuff. Located in Kennewick, WA

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Just to update. Only need the following parts still

-buckets
-nice tailgate
-inside spare tire carrier
-original spare

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Sent 59Bones a check for the grille and never heard back.

Still looking for

-Grille
-Buckets
-Tailgate
-original spare

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Did he cash your check? I have a few 74 GMC grilles.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

Do you still need a floor shift tilt column still? I have one from a 76 K20

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

For the spare, would a '73 or '75 spare (original tire and rim) work or are you going concours and need the '74 date code?
I may have some buckets also (out of a '75).
I have GMC grills also but I would suggest finding one in full chrome as I don't think there is a better looking square body grill once you strip the argent. I don't have a spare chrome one.
Everything is in MI.

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

PM’s sent
Posted via Mobile Device

Re: Wanted:74’ GMC Jimmy/Blazer parts
 

PM’s sent
Posted via Mobile Device