Carburetor help
 

Hi, I have a 1978 C10 with a 350 and a th350 trans. The engines a goodwrench crate motor casting number 10066036. It has a 2 barrel and I would like to upgrade to a 4 barrel. I found a kit on summit racing with Edelbrock 2701 intake and Edelbrock 600cfm carb (CMB-03-0077). I’m wondering if it will work. If not, what will work? I don’t know much but I’m trying to do it myself rather than pay someone to do it for me. Thanks for the help.

Re: Carburetor help
 

Welcome to the site!

Yes that intake will work fine. 600cfm carb is plenty for a stock 350 as well.

Be sure to read up if you’ve never done this swap before. The linkages will be completely different (I’m assuming you have a quadrajet currently) so you’ll need little things there, and sealing/gasket/install of the intake is critical. You will also need to ensure vacuum lines are going to the correct ports on the new carb.

Good luck!

Re: Carburetor help
 

Not the right time of the year to be swapping carbs and intakes. Do it in late spring.
The intake will work but an edelbrock carb might need a fuel regulator, a heat spacer and throttle/trans brackets.
I’d opt for a 2101 and rebuilt quadrajet.
And welcome from the rain forest of Van Isle!