How to adjust engine hood
 

can anyone offer advice or ideas on how to adjust the back of the engine hood to sit flush with the fenders?? not sure how to adjust the back of the hood to lower down??

thanks!!

Re: How to adjust engine hood
 

What year? There were a couple different hinge styles

Re: How to adjust engine hood
 

ooppss... sorry..... this would be related to late model trucks... in my case it is for a 1986 hood...

thanks!!

Re: How to adjust engine hood
 

Have you tried loosening the bolts that are thru the hinge, and into the hood? Those holes are oversized and slotted for adj..
Is it both sides or just the 1 side?
You could also possibly have bent hinges as well..has it always been this way,,or just recent?

Re: How to adjust engine hood
 

Mongocanfly is correct. I swap out my hood and it was high in the back like that. And those are the bolts in my picture that are circled. Loosen those up and pull the hood down, and tighten.
Last photo is after the hood was painted.

Re: How to adjust engine hood
 

guys.. thanks for the responses.. I will try those bolts to adjust. I will follow up on here as well, so hopefully it will help someone in the future too!!
thanks again for the responses... :)

Re: How to adjust engine hood
 

So the pic of the bolts shown wouldn't they be for front to back adjustment?
On my 68 the hinge fender bolts are the ones that affect the level at the back of the hood.
To get the hood to set lower on my 68 at the back loosen the back bolts on either side and slightly loosen the front bolts. Then push the front of the hood up and tighten the bolts. Close the hood slowly because will cause the hood to move back a bit.

Re: How to adjust engine hood
 

it does allow for front to back, and also up and down.. the 86 differs greatly from your 68
on the 86, the hinge mounts to a flat horizontal surface.. its possible you could shim the 86 up at this point..but not down