Oops, was I suppose to grease it?
So I have been slowly doing the ls swap in front of my sm465 and np 205, finally started the beast and it sounds like I have a dry pully in the clutch area,the clutch functions properly and the throw out bearing has proper clearance. The noise does not change when I push the clutch in or out, does seem to go quite the higher the rpms . last note is I may have neglected to grease the pilot bearing for the transmission,its a bearing and not a bushing but nonetheless I'm not sure whether I greased it or not for the snout of the input shaft,problem?.
|
Re: Oops, was I suppose to grease it?
Quote:
|
Re: Oops, was I suppose to grease it?
Quote:
I will snoop further |
Re: Oops, was I suppose to grease it?
Starter was just barely contacting flywheel, 2 starters to choose from a 9 toothe and 11, I used the starter from a automatic flywheel on my clutch flywheel and it is making contact at tip of gear,now you know.
|
Re: Oops, was I suppose to grease it?
Glad you figured it out and thanks for posting the solution for the next guy!
|
All times are GMT -4. The time now is 09:16 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com