Power Disc Brake install guidance
 

I FINALLY ordered my CCP Disc Brake conversion/upgrade.
Could anyone send me a few picture, of the orientation of the “Proportioning valve/block”.
I’m putting a Factory setup in with the Booster, MC, and Prop Valve.
It’s been many years since I took it off the donor truck, and can’t for the life of me remember how it went.
The picture is me holding holding the Valve the way I THINK it goes.
I know I need the Disc/Drum MC, and I pick it up in the morning.
As I said before a couple good clear pictures of a STOCK factory system would be worth a thousand words.
Thanks in advance

Re: Power Disc Brake install guidance
 

The rubber button goes toward the front of the truck.

Re: Power Disc Brake install guidance
 

Like this. Disregard the shiny piece of metal, it’s holding the button in so I can bleed the brakes. Notice the bleeder is on the top at the front. Sorry about the sideways pic.

Re: Power Disc Brake install guidance
 

Thanks. I was really scratching my behind on that one.
From the ”valve body”, does the line coming out of the rear, go to the back brakes? Then the one underneath (which is a smaller fitting) goes to the Front Brakes? Am I right in saying this?

Re: Power Disc Brake install guidance
 

Yes, that is correct

Re: Power Disc Brake install guidance
 

Thank you very much:metal:

Re: Power Disc Brake install guidance
 

No problem, good luck with the install.