PWM cooling fan for stock rad shroud
 

Still working on my 72 LQ9 swap and went looking for a cooling fan. I picked up a brushless fan from a Volvo XC90 that will be controlled by my Holley Term X. This fan if trimmed around the round fan enclosure fits into the 72 C10 factory shroud almost perfectly and will be controlled by Holley. I had to sand the perimeter of the Volvo shroud a little. I haven't figured out posting photos yet but I will keep trying.

Re: PWM cooling fan for stock rad shroud
 

The way I post pictures with my phone is, I e-mail them to myself.

Then I open the e-mail and save them to my computer.

Before I save them to my computer, I crop them just a little and name them so I don't have to remember image 7041.:lol:

Then I can start my post and use the (paper clip) attachment icon to the right side of the smiles and to the left side of the Undo icon.

Then click (choose file) and type / click on the picture you saved.

Then hit the upload button.

Hope this helps.

Re: PWM cooling fan for stock rad shroud
 

So, the fan is ready, just painted in this photo with trim black. It will dry to a satin finish.
Attachment 2434746

Re: PWM cooling fan for stock rad shroud
 

Thanks, it seems every forum has a little different procedure.

Re: PWM cooling fan for stock rad shroud
 

That for sure.;)

This is my Favorite forum.

:chevy::chevy::chevy:

Re: PWM cooling fan for stock rad shroud
 

I have a windstar dual fan setup in my 72 K10 6.0LS
My current build is a 68 short stepper 5.3LS stock rad with a grand caravan dual fan. The plastic shroud is a very good fit for the stock rad. just need some trimming with a zip wheel. $30 at the wrecker.

Re: PWM cooling fan for stock rad shroud
 

I used stock fans from an Escalade. No mods whatsoever. Even took the stock relay setup.