View Single Post
Old 11-01-2004, 09:23 PM   #2
JimKshortstep4x4
Senior Member
 
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
Smile

I just checked a couple of blower motors and got .6 and .7 ohms which is very close to your reading on your motor. It sounds like you are loosing contact slightly in your switch but that would not cause blowing of the fuses.

I suspect that you have a blower motor problem and you should be able to check the draw when it is running if you have the right ammeter setup. ( I use an ammeter that read by placing it over the wire).

Jim
JimKshortstep4x4 is offline   Reply With Quote