The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68w/sbc406 · 11-15-2004, 02:19 PM

dont know about the lowering part, but as far as the swap, if you look at my avatar you will see a 6 lug disc rotor, i bought it from Early Clasic Enterprises(ECE) but many of the board vendors sell this rotor too(http://67-72chevytrucks.com/) you will need to change upper and lower ball joints for this spindle, and as far as the tie rods, see if the threaded end that hook into the sleeve are the same thickness, if they are different thickness then you will either need to use the 72 steering stuff all the way across or purchase the adaptor sleeve that classic performance products carries(they are also a board vendor. ask more questions if you need
and if some one hasnt already done it, WELCOME TO THE BOARD form portland oregon

11-15-2004, 02:19 PM	#2
68w/sbc406 Got Light Emitting Diode? Join Date: Apr 2004 Location: Newberg, OR Posts: 2,485	dont know about the lowering part, but as far as the swap, if you look at my avatar you will see a 6 lug disc rotor, i bought it from Early Clasic Enterprises(ECE) but many of the board vendors sell this rotor too(http://67-72chevytrucks.com/) you will need to change upper and lower ball joints for this spindle, and as far as the tie rods, see if the threaded end that hook into the sleeve are the same thickness, if they are different thickness then you will either need to use the 72 steering stuff all the way across or purchase the adaptor sleeve that classic performance products carries(they are also a board vendor. ask more questions if you need and if some one hasnt already done it, WELCOME TO THE BOARD form portland oregon __________________ 1968 1/2 ton 2wd lwb 6 lug disc and bags up front. Next c notch and rear bags '02 Chevy Silverado LT ext cab short bed 2WD 5/7 drop on 22's(the family car) 1993 Cherokee work ride/weekend wheeler