|
I made my own cold-air induction by welding a pair of oval snorkels (with the hot air diverters) to a normal air cleaner bottom. I had to miss the distributor on one side and the air compressor on the other side. Then I used 4" exhaust tube and penetrated the core support and covered the inlet with a rain/snow dam. The air hits the core support and is guided through two right angle direction changes to knock the water and snow out before it could pack into the air filter. To connect the knockouts to the air cleaner I used 4" industrial woodshop sawdust hose.
I guess I gotta get off my butt and update the site.
__________________
Just as if I knew what I was doin'
|