View Single Post
Old 12-19-2004, 01:39 PM   #9
JIMs70GMC
user # 2756
 
JIMs70GMC's Avatar
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
The 205 is the only divorced TC with the eception of single speed NP200 and NP201s. As for the divorced set up, yes there is a short driveshaft between the two and it would be best to set the tc dead center of the front/rear axles so that your driveshafts front&rear would be the same. The 208 and 241 are aluminum cases that have to be attached to your tranny. Where they are coupled to the tranny one has a male and the other a female and they slide together.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs
1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX
1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears
1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now.....
1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone.
1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed.

1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm
JIMs70GMC is offline   Reply With Quote