The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

toddtheodd · 12-20-2004, 07:01 PM

Somebody said that I would need to go to a shop to get the bushings "pressed on." What is the truth behind this?
What kind of tools do I need to do this myself.
Cordless drill and air tools I have. I also have jackstands and a sawsall.
I don't have a lot of money, (if I did, I would just pay the $500 and let the shop do the work) so I can't afford too many upgrades. I already have 2 inch drop springs, so that will be nice.
How much do you figure this will cost me. Rough guesstimation if you could.
Todd

12-20-2004, 07:01 PM	#4
toddtheodd The oddest Todd around Join Date: May 2004 Location: Miami, Florida Posts: 1,418	Somebody said that I would need to go to a shop to get the bushings "pressed on." What is the truth behind this? What kind of tools do I need to do this myself. Cordless drill and air tools I have. I also have jackstands and a sawsall. I don't have a lot of money, (if I did, I would just pay the $500 and let the shop do the work) so I can't afford too many upgrades. I already have 2 inch drop springs, so that will be nice. How much do you figure this will cost me. Rough guesstimation if you could. Todd __________________ "The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY???