[cochino12]

Originally Posted by Jonboy

I happen to have the seats here at work. I took a pic of the passenger side, mostly because it was on top. The holes are spaced about 13", center to center. The drivers seat has a mount at the far left, and one that will end up on the trans tunnel, at the right of that seat.

I have a set of 98 ext. cab buckets in my Blazer now. To mount them, I lined up as many existing holes as I could, and drilled the remaining ones. I used grade 8 bolts and fender washers to mount them. Just find the biggest, thickest fender washers you can and bolt them in. You may need to make some adjustment for the height of the trans tunnel, but I am not 100% sure. My Blazer is 2wd, so it has the smaller hump, but I haven't set the bench seat in it yet, either.

Thanks! those look just like pretty close to the brackets in the blazer now? How do you thinkthey are they going to be width wise? (I know you said you havent actually put them in the blazer yet)