[spencra]

Thanks John for posting the pics. The cab will need rockers, one of the PO's popped on new cab corners. I wouldn't say it was a perfect job but it doesn't look bad. I took the windows out to check the condition under the seals and the rear window was perfect. The front window lip had some pitting but it wasn't that bad. The interior floor needs some work. One of the PO's cut a hole in the floor to put an automatic floor shift in (he did a crappy job on that) but I did buy a high hump for it because I wanted to put an sm465 in it (which I have to go with). The rear floor of the cab I assume will need some work too. The PO sprayed that insulation foam in the corner, I'm willing to bet it will need work there. If you're handy with the metal and welder then I would have to say that it's a pretty easy job.
The hood is pretty much shot on the front lip. There is a lot of rust through up there. I was looking for a hood for the truck and I found a perfect one. The only problem is that a truck came with it because the owner didn't want to sell the hood bt itself. That truck became my new project because it's pretty much whole.
I can't think of anything else at this point but it's a pretty simple truck, no special options, I think I might have some extras lying around to go with it. I just have to dig them up.