The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

ChadMorris · 02-12-2005, 01:05 PM

Allright, I need some help. I have been trying to find the stock manifold clamps for a 250. I swapped from an integrated head to a non so i could add a clifford manifold and 4 bbl, but the guy I got the engine from was using washers.......i have been to the chevy dealer, and he was no help...there was 2 kinds, but he wasn't sure which one I needed, and he would have to order them........anyone have a set kicking around they would like to sell?

Also,will a late model Tahoe bench seat fit in a '64 GMC truck?

thanks all

02-12-2005, 01:05 PM	#1
ChadMorris Newbie truck Rebuilder! Join Date: Dec 2004 Location: Huntsville, Al Posts: 160	250 manifold clamps Allright, I need some help. I have been trying to find the stock manifold clamps for a 250. I swapped from an integrated head to a non so i could add a clifford manifold and 4 bbl, but the guy I got the engine from was using washers.......i have been to the chevy dealer, and he was no help...there was 2 kinds, but he wasn't sure which one I needed, and he would have to order them........anyone have a set kicking around they would like to sell? Also,will a late model Tahoe bench seat fit in a '64 GMC truck? thanks all __________________ "Old Blue" 1964 GMC Fleetside in pieces 350 TPI with 700R4 tranny now installed( well kinda propped in place until the tranny crossmember is bolted in !!!!! 1995 Toyota 4runner , 197,000 miles and going... 2007 Honda Odyssey Van (Wifes car)