The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Bob Gervais · 03-20-2005, 07:40 PM

I'm replacing them on my 87 4WD Suburban, with Energy suspension poly mounts.

Problem 1--Bolts and most washers were not included in this kit, is there any place besides the dealer to get them? Or is there a reasonably priced mount kit that has all the hardware I'll need?

I have no problems with returning the Energy mount kit, since it looks like I'll be replacing most of the hardware anyhow.

Problem 2--I've got a few bolts that are just spinning but not loosening. I'm guessing that there's a nut of some sort that's inside the channels? I'm also guessing that I'll need to hole saw the floor panel to get to them? Anyone else ever run into this?

Thanks in advance.

03-20-2005, 07:40 PM	#1
Bob Gervais Truckless for the moment... Join Date: Jan 2005 Location: Cranston, RI Posts: 180	Body mounts I'm replacing them on my 87 4WD Suburban, with Energy suspension poly mounts. Problem 1--Bolts and most washers were not included in this kit, is there any place besides the dealer to get them? Or is there a reasonably priced mount kit that has all the hardware I'll need? I have no problems with returning the Energy mount kit, since it looks like I'll be replacing most of the hardware anyhow. Problem 2--I've got a few bolts that are just spinning but not loosening. I'm guessing that there's a nut of some sort that's inside the channels? I'm also guessing that I'll need to hole saw the floor panel to get to them? Anyone else ever run into this? Thanks in advance. __________________ 1987 V1500 GMC Suburban, 350 TBI, Flowtech dual exhaust, Rough Country 2" spring lift, 56" 3/4 ton rear spring conversion, 33" BFG All Terrains, and the smokescreen engine mod -- Former truck, searching for another now...