|
Just put the horn togather on my son,s Blazer. Here's how it goes:
1--wafer spring in 1st-cup side UP (outside edge rides on plastic part of wheel-hence no ground)-3 holes lined up with 3 screw holes.
2--metal cup with plastic insulator inside.
3--put metal cup with plastic insulator legs thru holes in wafer spring.
4--install 3 screws and tighten.
5--touch battery cable back to battery post (you did remove it before you started didn't you?). If horn blows lossen screws a little and center the wafer spring where it goes around the steering shaft nut.
6--If this does not work don't blame me, blame MURPHY
__________________
56 Chevy Bel-Air 2dr. HT (purchased new)
71 Chevy Cheyenne SWB PU (502HO)
65 GMC short bed step--work in progress and my gofer
|