The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - anyone using block hugger headers on 4x4's?

Daks · 03-31-2005, 01:58 PM

Flowtech makes a set of big block headers that are designed for a 4x4 truck in our years. They are listed around $170 and are (if I remember correctly) 1 and 3/4 inch diameter. They are the full length type however, but from what I was told by a speedshop that I spoke with about them "They fit beautifully" and "Do not interfere with anything"... I would take that with a grain of salt of course...

03-31-2005, 01:58 PM	#5
Daks I like crayons Join Date: Feb 2005 Location: Colorado Springs, CO Posts: 80	Flowtech makes a set of big block headers that are designed for a 4x4 truck in our years. They are listed around $170 and are (if I remember correctly) 1 and 3/4 inch diameter. They are the full length type however, but from what I was told by a speedshop that I spoke with about them "They fit beautifully" and "Do not interfere with anything"... I would take that with a grain of salt of course...