The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Putter · 04-08-2005, 12:35 PM

As far as I remember, you can install the bar. And if you are not running individual controls, you most likely WANT to install the bar. I mean, if you are gonna run just a front valve up/down, and one rear valve up/down, then the air pressure can 'transfer' back throught the lines to the opposite side as you round the corner, allowing the truck to body roll. If you run seperate valves for each bag, you shouldn't have any issues, but the sway bar is still a nice addition. I am sure that the BAG experts will chime in and add a ton more detailed information to this.

04-08-2005, 12:35 PM	#3
Putter More Cowbell.... Join Date: Mar 2004 Location: Puckett, MS Posts: 3,569	As far as I remember, you can install the bar. And if you are not running individual controls, you most likely WANT to install the bar. I mean, if you are gonna run just a front valve up/down, and one rear valve up/down, then the air pressure can 'transfer' back throught the lines to the opposite side as you round the corner, allowing the truck to body roll. If you run seperate valves for each bag, you shouldn't have any issues, but the sway bar is still a nice addition. I am sure that the BAG experts will chime in and add a ton more detailed information to this. __________________ *There once was a member from Puckett.....Who ( fill in the blank blank blank* ) bucket** Last edited by Putter; 04-08-2005 at 12:36 PM.