The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Wanted

**Yukon Jack** · 04-22-2005, 10:34 AM

The plate is 5" X 4"

The 61" dimension is from inside to inside.

The 46" dimension is also from inside to inside. That dimension was difficult to measure as the wheel hump is an obstruction for a straight measurement. Definitely do not rely on it being exact.

The 33.5" and the 41.25" are from the floor to the bottom pipe.

I did not measure the thickness of the plate but it is definitely not 1/2". I will measure it for you but I'm pretty sure it is 1/4".

I will also get the vertical dimension for you.

I would definitely recommend you use these dimensions just as guides so you can fit the rollbar precisely to your K5. My glove box does not mention the rollbar though I think this is a factory rollbar. Others might be able to confirm that from my pictures.

04-22-2005, 10:34 AM	#8
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,689	The plate is 5" X 4" The 61" dimension is from inside to inside. The 46" dimension is also from inside to inside. That dimension was difficult to measure as the wheel hump is an obstruction for a straight measurement. Definitely do not rely on it being exact. The 33.5" and the 41.25" are from the floor to the bottom pipe. I did not measure the thickness of the plate but it is definitely not 1/2". I will measure it for you but I'm pretty sure it is 1/4". I will also get the vertical dimension for you. I would definitely recommend you use these dimensions just as guides so you can fit the rollbar precisely to your K5. My glove box does not mention the rollbar though I think this is a factory rollbar. Others might be able to confirm that from my pictures. __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 Last edited by Yukon Jack; 04-22-2005 at 10:44 AM.