The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

1969 modified · 05-12-2005, 12:19 PM

Thanks newbe351, that's the same measurement I've got (about 1/16th of an inch). There are two flat supports on both sides of the wheel opening that I had to cut loose on both sides to repair a couple of holes that are created by the moisture that gets trapped behind these support. I replaced the supports to the original location, but I figured that I had created a warp. I have a feeling that there is supposed to be a slight dip on both sides. I have a decision to make......leave it like it is or make it flat while I'm doing the body work. Thanks for checking for me.

Modified69, 97 work truck, 94 lifted, 65 in process.

05-12-2005, 12:19 PM	#4
1969 modified Registered User Join Date: Aug 2004 Posts: 38	Thanks newbe351, that's the same measurement I've got (about 1/16th of an inch). There are two flat supports on both sides of the wheel opening that I had to cut loose on both sides to repair a couple of holes that are created by the moisture that gets trapped behind these support. I replaced the supports to the original location, but I figured that I had created a warp. I have a feeling that there is supposed to be a slight dip on both sides. I have a decision to make......leave it like it is or make it flat while I'm doing the body work. Thanks for checking for me. Modified69, 97 work truck, 94 lifted, 65 in process.