The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jostrans68 · 08-03-2002, 09:18 PM

one concern the so called Myth about fitting with doors is not a myth its not the opening front to rear you need to be concerned with unless you remove all floor bracing. Its the up and down and you just cant weld it into the old location as new parts not the same. I did this the first time got luck pass side was great drivers was high in back and the door rubbed. If yours fit great you got lucky but this is my 4th set and I always fit the door. Not meant to offend you just my experiance so far . Your project is looking good. Heres mine I did today just a little spot putty and Its done ...take care and keep on trucking...Jack

08-03-2002, 09:18 PM	#4
jostrans68 Jostrans68 Join Date: Mar 2001 Location: Bloomington indiana Posts: 1,182	one concern the so called Myth about fitting with doors is not a myth its not the opening front to rear you need to be concerned with unless you remove all floor bracing. Its the up and down and you just cant weld it into the old location as new parts not the same. I did this the first time got luck pass side was great drivers was high in back and the door rubbed. If yours fit great you got lucky but this is my 4th set and I always fit the door. Not meant to offend you just my experiance so far . Your project is looking good. Heres mine I did today just a little spot putty and Its done ...take care and keep on trucking...Jack Attached Images __________________ [CGTW Member former 67-72 now with a 96 silverado Last edited by jostrans68; 08-03-2002 at 09:22 PM.