The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Russell · 06-08-2005, 03:24 PM

hey guys!

Does anyone have any good ideas for how a guy can drill some new holes for a tranny crossmember? Specifically, how would I get the holes drilled up tops?

I've got one of the older 3 peice tranny crossmembers if that makes any difference. It has the main member that is suppost to bolt to the top, and two small support members that bolt to the bottom of the rails, and to the main member.

06-08-2005, 03:24 PM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Drilling new tranny crossmember holes hey guys! Does anyone have any good ideas for how a guy can drill some new holes for a tranny crossmember? Specifically, how would I get the holes drilled up tops? I've got one of the older 3 peice tranny crossmembers if that makes any difference. It has the main member that is suppost to bolt to the top, and two small support members that bolt to the bottom of the rails, and to the main member. __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)