The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Mudder · 04-15-2002, 11:41 AM

I removeed my rear coross member and made a new one out of angle iron. then welded a smaller piece to the backside of the new cross to bolt the tank straps and skid plate to. basically did the same to the front with angle iron. both of the pieces of angle iron lay flush with the top side of the frame. I do have a reciever hitch bolted to the bottom of my frame. i will try to figure out this new scanner i have and post some pics this week.

------------------
67 stepside 4x4 Owensville MO mudder67@hotmail.com

[This message has been edited by Mudder67 (edited April 15, 2002).]

04-15-2002, 11:41 AM	#10
Mudder Registered User Join Date: Feb 2001 Location: East Central, MO Posts: 11,336	I removeed my rear coross member and made a new one out of angle iron. then welded a smaller piece to the backside of the new cross to bolt the tank straps and skid plate to. basically did the same to the front with angle iron. both of the pieces of angle iron lay flush with the top side of the frame. I do have a reciever hitch bolted to the bottom of my frame. i will try to figure out this new scanner i have and post some pics this week. ------------------ 67 stepside 4x4 Owensville MO mudder67@hotmail.com [This message has been edited by Mudder67 (edited April 15, 2002).]