The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Attempt at new intake/exhaust for inline 250

shifty · 06-21-2005, 11:34 AM

Thanks, guys. I am going to shorten the rod by about an inch. I really need to do something about the bar itself though.

Here's one for you: My Z-bar (what I guess is the Z-bar) and the Y-shaped mount that holds it to the motor are both shot. The cloth rings and round rubber seals on both of them are totally shot. I really need to tear it down, clean it up and rebuild it.

Where do you find replacements for these rings and what are they called? Does it come in a kit or something?

06-21-2005, 11:34 AM	#7
shifty Questionable Join Date: Mar 2005 Location: Atlanta Posts: 13,373	Thanks, guys. I am going to shorten the rod by about an inch. I really need to do something about the bar itself though. Here's one for you: My Z-bar (what I guess is the Z-bar) and the Y-shaped mount that holds it to the motor are both shot. The cloth rings and round rubber seals on both of them are totally shot. I really need to tear it down, clean it up and rebuild it. Where do you find replacements for these rings and what are they called? Does it come in a kit or something? __________________ If I've got anything up for grabs, it'll be here: 7-hole gauge cluster for a 67-72 p/u FREE (link) I can't check the forum daily. If I don't reply to you within 24 hours, drop me a PM! I'm (hopefully) still alive and will reply faster to a PM.