The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jamis · 08-01-2005, 07:24 AM

I have a set that I use to break engines in with, just for kicks I tried them on one day. They collector points straight down at the cross member, no way to get an exhaust pipe to fit in the V8 position. I moved it back to the L6, that sat the collector just a hair behind the cross member but the exhaust pipe would hit the bottom rear lip of the cross member. The only ones that may fit are the ones with the collectors swept back a few degrees used in the L6 position. These are swept back but I think they are too wide to fit between the rails

08-01-2005, 07:24 AM	#8
jamis F.A.S.T. president Join Date: Sep 2003 Location: Florida Posts: 1,883	I have a set that I use to break engines in with, just for kicks I tried them on one day. They collector points straight down at the cross member, no way to get an exhaust pipe to fit in the V8 position. I moved it back to the L6, that sat the collector just a hair behind the cross member but the exhaust pipe would hit the bottom rear lip of the cross member. The only ones that may fit are the ones with the collectors swept back a few degrees used in the L6 position. These are swept back but I think they are too wide to fit between the rails __________________ F.A.S.T. President and Founder Fabricators for the Advancement of Sawsall Technology "A fear of the Sawsall is a sign of retarded sexual and emotional maturity." ~Sigmund Freud, "General Introduction to Psychoanalysis" Last edited by jamis; 10-05-2007 at 07:12 AM.