|
YOU CAN CUT A SIX BY SIX HOLE IN THE UPPER PART OF THE PLENUM AND ACCESS THE RUSTED AREAS, BUT SAVE THE PIECES YOU REMOVE FROM THE PLENUM AND SIMPLY REWELD THEM WHEN THE PATCH IS FINISHED. i RECENTLY DID THIS WITH THE TRUCK i AM WORKING ON, AND ONCE THE COWL PANEL IS BACK IN PLACE, YOU CAN NOT TELL THAT THE AREA WAS WORKED- THEREFORE YOU CAN FINISH IT AS YOU CHOOSE, THIS IS NOT A HARD REPAIR BUT TIME CONSUMING BECAUSE OF THE STRANGE ANGLES ETC. bE PREPARED TO HAVE MORE TO REPAIR THAN JUST THE COWL AREA AS THE LOWER AIR BOX (WHERE VENTS ARE) IS LIKELY RUSTED AS WELL AND THEN THERE ARE THE KICK PANELS. GOOD LUCK
|