Quote:
|
Originally Posted by Yukon Jack
Might as well leave it here as some might not see it in the other thread to add their own info. Here is a link to a page I put together with info about mounting these seats in my truck. I wish I would have used C channel under the cab for even more strength. Guess I can always change that.
http://yukon.b0xen.us/interiorweb.html
The measurement you want is from the back of the cab to the rear mounting hole on the seats, right? |
Thanks for the information.
Yes, that's the measurement I am looking for.
I am building 6 pieces of C channel, with holes drilled to match the seats, sandwiching the floor boards. Then I may weld them to the floor...
I don't think fender washers will hold up in an impact. I also tend to over engineer things. Should see the roll cage I put into my old blazer
